Specifies whether the default report type will be Summary or Detailed. Use these settings to establish the defaults for the Compute Quantity Takeoff dialog box. Note: This property group is displayed when you access the settings from the Takeoff command. When this setting is set to False, the open areas between surfaces are not closed automatically.
When set to True (which is the default), this setting specifies that open areas between surfaces are closed automatically with a vertical closure, as illustrated below. Apply Vertical Close Between Surfaces Automatically Specifies which method is used to calculate volumes. Enter an angle in degrees in the Value column or click and select an angle in the drawing area. If the sample lines are within the tolerance or if the angle of deflection between the successive stations is small, then curve correction is not used. Curve correction may be required to correct volume calculations within a curvilinear section of an alignment (or on two sides of a horizontal intersection point). Specifies whether curve correction is used when the Curve Correction Tolerance value is exceeded.
Use these settings to establish the default settings when you create a new quantity takeoff report. Note: This property group is displayed when you access the settings from the ComputeMaterials and GenerateQuantitesReport commands.
0 kommentar(er)
